Baxter Carbide, Inc.
Specialists In Carbide Fabrication
How long does it take to make special or non-stocked carbide parts?
Will your carbide run as well as Valenite, Kennametal, Carboloy, etc.?
Do you have an online catalog?
How do I become a distributor?
Who are some of the companies that use your products?
How long does it take to make special or non-stocked carbide parts?
It generally takes 2-3 weeks. If the parts are from non-standard, made to order blanks, it can take up to 4 weeks. Most semi specials such as grooving inserts with just a small change like width or radius can usually be done in under 2 weeks. Also allow approximately 1 additional week for coating.
Will your carbide run as well as Valenite, Kennametal, Carboloy, etc.?
Absolutley. We can supply parts that are very similar. We also have a wide range of coatings available as well. Please note however, application can vary. In some cases ours will run better or not as well. Generally this is only by a small percentage. This is the case anytime you change suppliers. In almost all cases, you will save money using our tools.
Do you have an online catalog?
Yes, Click Here to view our catalog in PDF format.How do I become a distributor?
Contact our sales department @ 800-370-6960.
Who are some of the companies that use your products?
GE, IBM, Tyco, Black & Decker, Briggs & Stratton, John Deere, Torrington and Ford. In addition we have many small manufacturers and machine shops all over the USA.
Stock inserts are usually sold in packs of 10 each. Made to order inserts are usually in 20 pc minimum.
We ship products using UPS and the U.S. Postal Office. We will gladly ship direct using your UPS number.
800-370-6960 support@baxtercarbide.com